2009 Dodge Challenger Owner's Manual - Page 346

344 WHAT TO DO IN EMERGENCIES 24. Connect the air pump hose valve to the tire valve and 28. Disconnect the TIREFIT system from the tire and flip the hose valve closed. reinstall the valve cap. 25. Check the pressure in the tire by reading the pressure gauge 4. If the pressure is 19 psi (1.3 bar) or greater, proceed to the following step. NOTE: If the pressure is less than 19 psi (1.3 bar), the tire is too badly damaged. Do not attempt to drive the vehicle further. Call for assistance. 29. Place the sealant kit back in the trunk of the vehicle. Replace the sealant bottle at your nearest authorized MOPAR parts dealership. 30. Have the tire inspected at the earliest opportunity at an authorized dealer or tire service center. NOTE: 26. Leave the parking brake set and the shift lever in • If a pressure of at least 19 psi (1.3 bar) cannot be PARK (automatic transmission) or gear (manual transmaintained in the tire, the tire is too badly damaged. mission) and start the engine. Do not attempt to drive the vehicle further. Call for assistance. 27. Inflate the tire to the pressure indicated on the tire pressure label on the driver-side latch pillar by pressing • Do not operate the electric air pump for more than the switch 3 on the air pump to I (ON) and watching the eight minutes to avoid overheating. The air pump may pressure gauge. When the tire pressure is set to the be used again once it has cooled down. pressure indicated on the tire pressure label, press the AIR PUMP switch 3 to 0 (OFF) and turn off the engine. • Replace the TIREFIT sealant bottle 5 once every four years to assure optimum operation of the system.