2010 Hummer H3 Owner's Manual - Page 242

9-58 Driving and Operating 3. Press T at the end of the lever and release it. 4. Take your foot off the accelerator pedal. Resuming a Set Speed Suppose the cruise control is set at a desired speed and then you apply the brake or step on the clutch. This disengages the cruise control. But it does not need to be reset. Once the vehicle is going about 40 km/h (25 mph) or more, move the cruise control switch briefly from R to S. The cruise symbol on the instrument panel comes on when the cruise control is engaged. The vehicle goes back to the chosen speed and stays there. If the switch is held at resume/ accelerate the vehicle keeps going faster until the switch is released or the brake is applied. Do not hold the switch at resume/accelerate, unless you want the vehicle to go faster. Setting Cruise Control { WARNING If you leave your cruise control on when you are not using cruise, you might hit a button and go into cruise when you do not want to. You could be startled and even lose control. Keep the cruise control switch off until you want to use cruise control. 1. Move the cruise control switch to on. 2. Get up to the speed desired.