2010 Hummer H3 Owner's Manual - Page 351
2010 Hummer H3 Manual
Page 351 highlights
Vehicle Care 5. Turn the lug wrench clockwise to raise the jack until it lifts the secondary latch spring. 6. Keep raising the jack until the spare tire stops moving upward and is held firmly in place. This lets you know that the secondary latch has released and the spare tire is balancing on the jack. 10-85 9. Tilt the retainer and slip it through the wheel opening when the spare tire has been completely lowered. 10. Turn the lug wrench clockwise to raise the cable back up if the cable is hanging. Have the hoist shaft assembly inspected as soon as you can. You will not be able to store a spare tire using the hoist assembly until it has been repaired or replaced. 8. Disconnect the lug wrench from the jack and carefully remove the jack. Use one hand to push against the spare tire while firmly pulling the jack out from under the spare tire with the other hand. Full-Size Spare Tire The vehicle, when new, had a fully-inflated spare tire. A spare tire may lose air over time, so check its inflation pressure regularly. See Tire Pressure on page 10‑51 and Vehicle Load Limits on page 9‑27 for information regarding proper tire inflation and loading your vehicle. For instruction on how to remove, install or store a spare tire, see Tire Changing (H3T) on page 10‑66 or Tire Changing (H3) on page 10‑75. 7. Lower the jack by turning the lug wrench counterclockwise. Keep lowering the jack until the spare tire slides off the jack.