2010 Hummer H3 Owner's Manual - Page 54
2010 Hummer H3 Manual
Page 54 highlights
3-10 Seats and Restraints To return the seatback(s) to the upright position: 1. Lift the seatback partially and reinsert the headrest. 2. Lift the seatback completely and push it into place. { WARNING A safety belt that is improperly routed, not properly attached, or twisted will not provide the protection needed in a crash. The person wearing the belt could be seriously injured. After raising the rear seatback, always check to be sure that the safety belts are properly routed and attached, and are not twisted. 4. Reconnect the center safety belt latch plate to the mini buckle. Make sure the safety belt is not twisted. 5. Push and pull on the latch plate to be sure it is secure. When the seatback is not in use, it should be kept in the upright, locked position. Safety Belts This section of the manual describes how to use safety belts properly. It also describes some things not to do with safety belts. { WARNING If either seatback is not locked, it could move forward in a sudden stop or crash. That could cause injury to the person sitting there. Always push and pull on the seatbacks to be sure they are locked. 3. Make sure the seatback is locked by pushing and pulling on it. { WARNING Do not let anyone ride where a safety belt cannot be worn properly. In a crash, if you or your passenger(s) are not wearing safety belts, the injuries can be much worse. You can hit things inside the vehicle harder or be ejected from the vehicle. You and your passenger(s) can be seriously injured or killed. In the same crash, you might not be, if you are buckled up. Always fasten your safety belt, and check that your passenger(s) are restrained properly too.