2012 Jeep Wrangler Owner Manual - Page 288

286 UNDERSTANDING YOUR INSTRUMENT PANEL • Magnetic materials should be kept away from the top button on the steering wheel (for approximately ten of the center of the instrument panel. This is where the seconds) until the current variance zone number is displayed. To change the zone, press and release the STEP compass sensor is located. button to increase the variance one step. Repeat as necessary until the desired variance is achieved. NOTE: The factory default zone is 8. During programming, the zone value will wrap around from zone 15 to zone 1. Manual Compass Calibration If the compass appears erratic, inaccurate or abnormal, you may wish to calibrate the compass. Prior to calibrating the compass, make sure the proper zone is selected. 1. Start the engine and leave the transmission in the PARK position. Compass Variance Map 2. Press and hold the RESET button (for approximately To Set The Variance Start the engine and leave the transmission gear selector 10 seconds) until the current variance zone number is lever in the PARK position. Press and hold the RESET displayed.