2012 Jeep Wrangler Owner Manual - Page 89

THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 87 inspect the exhaust system each time the vehicle is raised authorized dealer. If the light stays on, flickers, or comes on while driving, have the system checked by an authofor lubrication or oil change. Replace as required. rized dealer. Safety Checks You Should Make Inside The Vehicle Defroster Check operation by selecting the defrost mode and place Seat Belts the blower control on high speed. You should be able to Inspect the belt system periodically, checking for cuts, feel the air directed against the windshield. See your frays, and loose parts. Damaged parts must be replaced authorized dealer for service if your defroster is immediately. Do not disassemble or modify the system. inoperable. Front seat belt assemblies must be replaced after a Floor Mat Safety Information collision. Rear seat belt assemblies must be replaced after Always use floor mats designed to fit the footwell of your a collision if they have been damaged (i.e., bent retractor, vehicle. Use only floor mats that leave the pedal area torn webbing, etc.). If there is any question regarding belt unobstructed and that are firmly secured so that they or retractor condition, replace the belt. cannot slip out of position and interfere with the pedals Air Bag Warning Light or impair safe operation of your vehicle in other ways. The light should come on and remain on for four to eight seconds as a bulb check when the ignition switch is first turned ON. If the light is not lit during starting, see your 2