2012 Jeep Wrangler Owner Manual - Page 543

MAINTAINING YOUR VEHICLE 541 Drain fluid level. Refer to "Fluids, Lubricants, and Genuine First remove the fill plug (B), then the drain plug (C). The Parts" in "Maintaining Your Vehicle" for further informarecommended tightening torque for the drain and fill tion. plugs is 15 to 25 ft lbs (20 to 34 N·m). Fluid Level Check Lubricant should be at the bottom edge of the oil fill hole. CAUTION! When replacing the plugs, do not overtighten them. You could damage them and cause them to leak. Selection Of Lubricant Use only manufacturer's recommended fluid. Refer to "Fluids, Lubricants, and Genuine Parts" in "Maintaining Your Vehicle" for further information. Front/Rear Axle Fluid For normal service, periodic fluid level checks are not required. When the vehicle is serviced for other reasons the exterior surfaces of the axle assembly should be inspected. If gear oil leakage is suspected inspect the Adding Fluid Add lubricant only at the fill hole and only to the level specified above. Selection Of Lubricant Use only manufacturer's recommended fluid. Refer to "Fluids, Lubricants, and Genuine Parts" in "Maintaining Your Vehicle" for further information. Appearance Care And Protection From Corrosion Protection Of Body And Paint From Corrosion Vehicle body care requirements vary according to geographic locations and usage. Chemicals that make roads passable in snow and ice, and those that are sprayed on 7