2012 Jeep Wrangler Owner Manual - Page 294
2012 Jeep Wrangler Manual
Page 294 highlights
292 UNDERSTANDING YOUR INSTRUMENT PANEL • Gate Ajar (with vehicle graphic showing the Liftgate/ Unless reset, this message will continue to display each time you turn the ignition switch to the ON position. To back door open and A single chime ) turn off the message temporarily, press and release the • Check Gascap (refer to "Adding Fuel" in "Starting MENU button. To reset the oil change indicator system And Operating" for more details) (after performing the scheduled maintenance), perform the following procedure: • Oil Change Required (with a single chime) • ECO (Fuel Saver Indicator) - if equipped Oil Change Required Your vehicle is equipped with an engine oil change indicator system. The "Oil Change Required" message will flash in the EVIC display for approximately 10 seconds after a single chime has sounded to indicate the next scheduled oil change interval. The engine oil change indicator system is duty cycle based, which means the engine oil change interval may fluctuate dependent upon your personal driving style. 1. Turn the ignition switch to the ON position. Do not start the engine. 2. Fully depress the accelerator pedal slowly three times within 10 seconds. 3. Turn the ignition switch to the LOCK position. NOTE: If the indicator message illuminates when you start the vehicle, the oil change indicator system did not reset. If necessary, repeat this procedure.