2009 Mercedes CLK-Class Owner's Manual - Page 106
2009 Mercedes CLK-Class Manual
Page 106 highlights
Controls in detail Power windows where you pulled the switch past the resistance point and released it to close the window, the automatic reversal function will stop the window and open it slightly. If a door window encounters an obstruction that blocks its path in a circumstance where you are closing the window by pulling and holding the switch, by pressing and holding button j on the SmartKey, by pressing and holding the lock button (vehicles with KEYLESS-GO) on an outside door handle, or CLK cabriolet: by operating the soft top switch, the automatic reversal function will not operate. Activate the override switch when children are riding in the back seats of the vehicle. The children may otherwise injure themselves, e.g. by becoming trapped in the door window opening. X X i You can also open or close the windows using the SmartKey, see "Summer opening feature" (Y page 105) and "Convenience closing feature" (Y page 106). i After switching off the ignition or removing the SmartKey from the starter switch, you can operate the windows until you open a door. If no door was opened you can operate the windows for up to 5 minutes. Switch on the ignition. Opening/Closing: Press or pull and hold switch 1 to 4 to the resistance point. The corresponding window will move downwards or upwards until you release the switch. X Express operation: Press or pull switch 1 or 2 past the resistance point and release. The corresponding door window opens or closes completely. X Stopping during express operation: Press or pull the respective switch again. G Observe Safety notes, see page 58. G Warning! If you pull and hold the switch up when closing the door window, and upward movement of the door window is blocked by some obstruction including but not limited to arms, hands, fingers, etc., the automatic reversal will not operate. 1 Left door window 2 Right door window 3 Right rear side window 4 Left rear side window ! If the upward movement of a door window is blocked during the closing procedure, the door window will stop and open slightly. Remove the obstruction, pull the respective power window switch again past the resistance point and release. If the door window still does not close when there is no obstruction, pull and hold the respective power window switch. The door window will then close without the obstruction sensor function. G Warning! Driver's door only: If within 5 seconds the switch is again pulled past the resistance 104