2009 Mercedes CLK-Class Owner's Manual - Page 168
2009 Mercedes CLK-Class Manual
Page 168 highlights
Controls in detail Audio system X Terminating a combined call: Press button t. The connection to both callers is terminated. TDMA or CDMA network phones G Warning! Please do not forget that your primary responsibility is to drive the vehicle. A driver's attention to the road must always be his/her primary focus when driving. For your safety and the safety of others, we recommend that you pull over to a safe location and stop before placing or taking a telephone call. If you choose to use the mobile phone7 while driving, please use the hands-free device and only use the mobile phone when road, weather and traffic conditions permit. Some jurisdictions prohibit the driver from using a mobile phone while driving a vehicle. Bear in mind that at a speed of just 30 mph (approximately 50 km/h), your vehicle is covering a distance of 44 feet (approximately 14 m) every second. 7 Using your Mercedes-Benz specified mobile phone, a number of functions and operating steps can be performed and displayed in the audio system display. Further operating instructions not covered here can be found in the operating instructions for the multifunction steering wheel and the mobile phone. If your audio system is set up for telephone operation, the t symbol will appear in the display. When you insert your Mercedes-Benz specified mobile phone into the mobile phone cradle, you will be prompted to enter your PIN for 30 seconds (Y page 162). This display disappears when you press any button. When your mobile phone is inserted into the mobile phone cradle, you will see the reception strength in the upper right-hand corner of the display. X X Enter code using buttons 1 to R. If necessary, correct number entered with the CLR soft key. Press soft key briefly to delete the last digit entered; press soft key and hold to delete the complete number. X Press OK soft key after entering correct code. The telephone is unlocked. If you have entered an incorrect code, you must enter the correct code. Switching off the telephone X Press button h for approximately three seconds. PROCESSING appears in the display until the telephone is off. Afterward, PHONE OFF appears in the display. Switching on the telephone Switching on the telephone X Press button h. If you have programmed an unlock code for the telephone, you must now enter the code. Observe all legal requirements. 166