2009 Mercedes CLK-Class Owner's Manual - Page 346
2009 Mercedes CLK-Class Manual
Page 346 highlights
Practical hints Flat tire ! Do not position the jack on the body of the vehicle, as this may cause damage to the vehicle. 1 Wheel wrench X X On wheel to be changed, loosen but do not yet remove the wheel bolts (approximately one full turn with wrench 1). The jack take-up brackets are located directly behind the front wheel housings and in front of the rear wheel housings. 2 Take-up bracket 3 Jack 4 Crank X Turn crank 4 clockwise until jack 3 is fully seated in take-up bracket 2 and the jack base evenly meets the ground. X Jack up the vehicle until the wheel is a maximum of 1.2 in (3 cm) from the ground. G Warning! The jack is designed exclusively for jacking up the vehicle at the jack take-up brackets. Make sure the jack arm is fully seated in the jack take-up bracket. If you do not position the jack correctly in the jack take-up bracket, the vehicle can fall off the jack and seriously or fatally injure you or others. Place jack 3 on firm ground. X Position jack 3 under take-up bracket 2 so that it is always vertical as seen from the side, even if the vehicle is parked on an incline. 344