1999 Nissan Pathfinder Owner's Manual - Page 156

1) Move the selector lever into the P (Park) position. 2) Turn the ignition key slightly in the ON direction. 3) Turn the key toward the LOCK position. 4) Remove the key. If the key is removed from the ignition switch, the selector lever cannot be moved from P (Park). The selector lever can be moved if the ignition switch is in the ACC position. This allows the vehicle to be moved if the battery is discharged. The selector lever can also be moved if the ignition switch is in the ON position and the foot brake pedal is depressed. There is an OFF position in between LOCK and ACC, although it does not show on the lock cylinder. When the ignition is in OFF the steering wheel is not locked. In order for the steering wheel to be locked, it must be turned about 1/6 of a turn clockwise from the straight up position. To lock the steering wheel, remove the key. To unlock the steering wheel, insert the key and turn it gently while rotating the steering wheel slightly right and left. Never remove the key while driving. If the key is removed, the steering wheel will lock. This may cause the driver to lose control of the vehicle and could result in serious vehicle damage or personal injury. KEY POSITIONS LOCK (Normal parking position) (0) OFF (1) The engine can be turned off without locking the steering wheel. ACC (Accessories) (2) This position activates electrical accessories such as the radio when the engine is not running. ON (Normal operating position) (3) This position turns on the ignition system and the electrical accessories. START (4) This position activates the starter motor, starting the engine. Starting and driving SSD0083 AUTOMATIC TRANSMISSION On automatic transmission models, the ignition lock is designed so that the key cannot be turned to LOCK and removed until the selector lever is moved to the P (Park) position. When removing the key from the ignition, make sure the selector lever is in the P (Park) position. If the selector lever is not returned to P (Park), the key cannot be moved toward LOCK. When the key cannot be turned toward the LOCK position, proceed as follows to remove the key: 5-7