1999 Nissan Pathfinder Owner's Manual - Page 167

BREAK-IN SCHEDULE ACCEL set switch. Each time you do this, the set speed will increase by about 1 MPH (1.6 km/h). To reset at a slower cruising speed, follow either of these three methods: a) Lightly tap the brake pedal. When the vehicle attains the desired speed, push the COAST/SET switch and release it. b) Push and hold the COAST/SET switch. Release the switch when the vehicle slows down to the desired speed. c) Push, then quickly release the COAST/ SET switch. Each time you do this, the set speed will decrease by about 1 MPH (1.6 km/h). To resume the preset speed, push and release the resume set switch. The vehicle will resume the last set cruising speed when the vehicle speed is over 30 MPH (48 km/h). order indicated. (This is a fail-safe mode. Turn the main switch OFF and turn it ON again without pushing the set switch to return to normal operation.) ¼ If the cruise control system malfunctions, it will cancel automatically. The cruise indicator in the meter assembly will then blink to warn the driver. ¼ When the cruise indicator blinks, turn the cruise control switch (Main switch) OFF and have the system checked by your NISSAN dealer. During the first 1,000 miles (1,600 km), follow these recommendations for the future reliability and economy of your new vehicle. Failure to follow these recommendations may result in vehicle damage or shortened engine life. ¼ Do not run the engine over 4,000 rpm. Do not drive over the following speed limits: Two wheel drive models: Four wheel drive models (2H position): 55 MPH (90 km/h) Four wheel drive models (4H position): 50 MPH (80 km/h) Four wheel drive models (4L position): 30 MPH (50 km/h) ¼ Do not accelerate hard in top gear. ¼ Avoid quick starts and full acceleration. ¼ Avoid hard stops as much as possible. ¼ For the first 300 miles (500 km), it is recommended that you drive in the two wheel drive (2H) position. ¼ Do not tow a trailer for the first 500 miles (800 km). Precautions ¼ The cruise indicator may sometimes blink when the cruise control switch (Main switch) is turned ON while pushing the RES/ACCEL switch or COAST/SET switch or CANCEL switch (located on the steering wheel). To properly set the cruise control system perform the steps above in the 5-18 Starting and driving