2005 Nissan 350Z Owner's Manual - Page 147
2005 Nissan 350Z Manual
Page 147 highlights
Audio main operation ON⋅OFF/Volume control: Turn the ignition key to ACC or ON, and then push the ON⋅OFF/VOL (Volume) control knob while the system is off to call up the mode (radio or CD) which was playing immediately before the system was turned off. When no CD is loaded, the radio will come on. While the system is on, pushing the ON⋅OFF/VOL control knob turns the system off. Turn the ON⋅OFF/VOL control knob to adjust the volume. AUDIO button (BASS, TREBLE, FADER, BALANCE): Press the AUDIO button to change the selecting mode as follows. BASS → TREBLE → FADER → BALANCE To adjust Bass, Treble, Fader and Balance, press the AUDIO button until the desired mode (BASS, TREBLE, FADER or BALANCE) appears in the display. Press the TUNE , ) or SEEK ( , ) button ( to adjust Bass and Treble to the desired level. Use the TUNE or SEEK button also to adjust Fader or Balance modes. Fader adjusts the sound level between the front and rear speakers and Balance adjusts the sound between the right and left speakers. After 10 seconds, the radio or CD display reappears. Once the sound quality is set to the desired level, press the AUDIO button repeatedly until the radio or CD display appears. DISP DISPLAY CHANGE: Push the DISP button for more than 1.5 seconds to adjust the digital clock display. See "Clock" in the "2. Instruments and controls" section for the clock adjustment operation. When the DISP button is pushed for less than 1.5 seconds while the compact disc is being played, the display will show the CD play time. the power knob is turned to ON. If a compact disc is playing when the FM or AM band select button is turned to ON, the compact disc will automatically be turned off and the last radio station played will come on. The FM stereo indicator ST will glow during FM stereo reception. When the stereo broadcast signal is weak, the radio will automatically change from stereo to monaural reception. TUNE (Tuning): WARNING The radio should not be tuned while driving so full attention may be given to vehicle operation. or for manual Use the TUNE button tuning. To move quickly through the channels, hold either side of the TUNE button down for more than 0.5 seconds. SEEK tuning: or to tune Push the SEEK button from high to low or low to high frequencies and stops at the next broadcasting station. FM-AM radio operation FM/AM band select: Pushing the FM band select button will change the band as follows: FM1 → FM2 → FM1 To select the AM band, push the AM band select button. When FM or AM band select button is pushed while the ignition switch is in the ACC or ON, the radio will come on at the station last played. The last station played will also come on when 4-16 Heater, air conditioner and audio systems