2005 Nissan 350Z Owner's Manual - Page 152
2005 Nissan 350Z Manual
Page 152 highlights
FM-AM-SAT radio operation RADIO (FM/AM/SAT) band select: Pushing the RADIO (FM/AM/SAT) band select button will change the band as follows: (Without satellite radio) AM → FM1 → FM2 → AM (With satellite radio) AM → FM1 → FM2 → SAT1 → SAT2 → AM Satellite radio reception capability is not functional, and "NO SAT" will be displayed during scrolling of modes, unless optional satellite receiver and antenna were factory installed or dealer installed prior to purchase, and an XM or SIRIUSTM satellite radio service subscription is active. When RADIO band select button is pushed while the ignition switch is in the ACC or ON, the radio will come on at the station last played. The last station/channel played will also come on when the ON⋅OFF/VOL control knob is pushed to ON. If a compact disc or tape is playing when the RADIO band select button is turned to ON, the compact disc or tape will automatically be turned off and the last radio station/channel played will come on. The FM stereo indicator ST will glow during FM stereo reception. When the stereo broadcast signal is weak, the radio will automatically change from stereo to monaural reception. TUNE (Tuning): SCAN tuning: Push the SCAN tuning button to tune from low to high frequencies and stops at each broadcasting station for 5 seconds. Pushing the button again during this 5 second period will stop SCAN tuning and the radio will remain tuned to that station. If the SCAN tuning button is not pushed within 5 seconds, SCAN tuning moves to the next station. DISP SAT radio display change: ¼ Pushing the DISP button will display additional information (for example: Title, Artist name) about the satellite radio broadcast. ¼ Pushing the DISP button for more than 1.5 seconds will change the display mode as follows: Channel number → Channel name → Artist name → Song title → Channel number Station memory operations: Twelve stations/channels can be set for the FM band (six for FM1, six for FM2) and the SAT radio (six for SAT1, six for SAT2), and six stations can be set for the AM band. 1. Tune to the desired station/channel using the SEEK, SCAN or TUNE button. WARNING The radio should not be tuned while driving so full attention may be given to vehicle operation. or for manual Use the TUNE button tuning. To move quickly through the channels, hold either side of the TUNE button down for more than 0.5 seconds. SEEK tuning: (For FM and AM radio) or to tune Push the SEEK button from high to low or low to high frequencies and stops at the next broadcasting station. (For satellite radio) Push the SEEK button or to seek channels of the next or previous category. Heater, air conditioner and audio systems 4-21