2005 Nissan 350Z Owner's Manual - Page 151

receiver and antenna are installed (retrofit unavailable without factory satellite radio prewiring), and an XM® or SIRIUSTM satellite radio service subscription is active. Turn the ON⋅OFF/VOL control knob to adjust the volume. AUDIO button: Press the AUDIO button to change the selecting mode as follows. BASS → TREBLE → FADER → BALANCE → NR (Dolby; when cassette is playing) → AUDIOP (Audio Pilot) To adjust Bass, Treble, Fader and Balance, press the AUDIO button until the desired mode (BASS, TREBLE, FADER or BALANCE) appears in the display. Press the TUNE ( , ) or SEEK ( , ) button to adjust Bass and Treble to the desired level. Use the TUNE or SEEK button also to adjust Fader or Balance modes. Fader adjusts the sound level between the front and rear speakers and Balance adjusts the sound between the right and left speakers. To change the NR (Dolby) mode to OFF or ON, press the TUNE or SEEK button while cassette tape is playing. When Dolby is ON, the display indicates the mark. To change the AUDIOP (Audio Pilot) mode to OFF or ON, press the TUNE or SEEK button. Once you have adjusted the sound quality to the desired level, press the AUDIO button repeat- edly until the radio, cassette tape or CD display reappears. Otherwise, the radio, cassette tape or CD display will automatically reappear after about 10 seconds. Dolby NR (Noise reduction): Dolby noise reduction is manufactured under license from Dolby Laboratories Licensing Corporation. Dolby NR and the double-D symbol are trademarks of Dolby Laboratories Licensing Corporation. Metal or chrome tape usage: The cassette player will be automatically set to high performance play when playing a metal or chrome cassette tape. CLOCK adjusting: Push the RPT button for more than 1.5 seconds to adjust the digital clock display. When the clock adjusting display is selected, the time (hour or minute) will start flashing. See "Clock" in the "2. Instruments and controls" section for the detailed clock adjustment operation. DISP DISPLAY CHANGE: This button will work during satellite radio (if so equipped) and CD operation. Find the detailed function in the description of each item. Audio main operation Head unit: The tape deck employs a permalloy head which allows for improved reproduction of high frequency ranges. Noise is also greatly reduced by the use of the Dolby NR (Noise Reduction) system. The auto loudness circuit enhances the low frequency range automatically in both radio reception and tape and CD playback. This audio system has an active noise compensation feature called "Audio Pilot". The Audio Pilot uses a microphone to detect external road noise and automatically adjusts the amplifier to compensate for any competing high, midrange, or low frequency noise. ON⋅OFF/Volume control: Turn the ignition key to ACC or ON, and then push the ON⋅OFF/VOL (Volume) control knob while the system is off to call up the mode (radio, tape or CD) which was playing immediately before the system was turned off. When no CD or tape is loaded, the radio will come on. While the system is on, pushing the ON⋅OFF/VOL control knob turns the system off. 4-20 Heater, air conditioner and audio systems