2005 Nissan 350Z Owner's Manual - Page 35
2005 Nissan 350Z Manual
Page 35 highlights
8. Check to make sure that the child restraint is properly secured prior to each use. If the lap belt is not locked, repeat steps 4 through 7. After the child restraint is removed and the seat belt is allowed to wind back into the retractor, the automatic locking mode (child restraint mode) is canceled. 6. Before placing the child in the child restraint, use force to push the child restraint from side to side, and tug it forward to make sure that it is securely held in place. It should not move more than 1 in (25 mm). If it does move more than 1 in (25 mm), pull again on the shoulder belt to further tighten the child restraint. If unable to properly secure the restraint, try a different child restraint. Not all child restraints fit in all types of vehicles. 7. Check that the retractor is in the automatic locking mode by trying to pull more belt out of the retractor. If you cannot pull any more belt webbing out of the retractor, the belt is in the automatic locking mode. Front facing - step 6 SSS0302B Rear facing Rear facing - step 2 SSS0211A When you install a child restraint in the front seat, follow these steps: 1. Turn the air bag ON/OFF switch to the OFF position. Turn the seatback tilt cancel switch to the CANCEL position. (Roadster models only) 2. Position the child restraint on the front passenger seat. Move the seat to the rearmost position. The direction of the child restraint depends on the type of the child restraint and the size of the child. Always follow the restraint manufacturer's instructions. 1-22 Safety - Seats, seat belts and supplemental restraint system