2005 Nissan 350Z Owner's Manual - Page 217

AUTOMATIC TRANSMISSION FLUID CAUTION The dipstick must be inserted in place to prevent oil spillage from the dipstick hole while filling the engine with oil. See "Capacities and recommended fuel/ lubricants" in the "9. Technical and consumer information" section for drain and refill capacity. The drain and refill capacity depends on the oil temperature and drain time. Use these specifications for reference only. Always use the dipstick to determine the proper amount of oil in the engine. 10. Start the engine and check for leakage around the drain plug and the oil filter. Correct as required. 11. Turn the engine off and wait more than 10 minutes. Check the oil level with the dipstick. Add engine oil if necessary. hole in the frame, then push the center of the clip in to lock the clip in place. d. Install the other bolts that hold the undercover in place. Be careful not to strip the bolts or over-tighten them. 2. Lower the vehicle carefully to the ground. 3. Dispose of waste oil and filter properly. When checking or replacement is required, we recommend a NISSAN dealer for servicing. CAUTION ¼ Use only Genuine Nissan Matic J ATF. Do not mix with other fluids. ¼ Using automatic transmission fluid other than Genuine Nissan Matic J ATF will cause deterioration in driveability and automatic transmission durability, and may damage the automatic transmission, which is not covered by the NISSAN new vehicle limited warranty. The specified automatic transmission fluid is also described on caution labels located in the engine compartment. WARNING ¼ Prolonged and repeated contact with used engine oil may cause skin cancer. ¼ Try to avoid direct skin contact with used oil. If skin contact is made, wash thoroughly with soap or hand cleaner as soon as possible. ¼ Keep used engine oil out of reach of children. After the operation 1. Install the engine undercover into position as outlined in the following steps. a. Pull the center of the small plastic clip out. b. Hold the engine undercover into position. c. Insert the clip through the undercover into the 8-12 Maintenance and do-it-yourself