2005 Nissan 350Z Owner's Manual - Page 67

turned OFF may continue to be displayed. ¼ When driving uphill or rounding curves, the fuel in the tank shifts, which may momentarily change the display. first 30 seconds after a reset, the display shows (----). Elapsed time (h:m:s) and trip odometer (mls or km) Elapsed time: The elapsed time mode shows the time since the last reset. The displayed time can be reset by B pressing the trip computer setting switch k for more than approximately 1 second. (The trip odometer is also reset at the same time.) Trip odometer: The trip odometer mode shows the total distance the vehicle has been driven since the last reset. Resetting is done by pressing the setting B switch k for more than approximately 1 second. (The elapsed time is also reset at the same time.) Even if the display is switched to the other mode while the time is starting, the stopwatch continues to advance until you stop the time in the stopwatch mode. When the ignition switch is turned OFF, the time is reset. Average fuel consumption (mpg or l (liter)/100 km) and speed (av. mph or av. km/h) Fuel consumption: The average fuel consumption mode shows the average fuel consumption since the last reset. Resetting is done by pressing the trip computer B setting switch k for more than approximately 1 second. (The average speed is also reset at the same time.) The display is updated every 30 seconds. At about the first 1/3 miles (500 m) after a reset, the display shows (----). Speed: The average speed mode shows the average vehicle speed since the last reset. Resetting is B done by pressing the setting switch k for more than approximately 1 second. (The average fuel consumption is also reset at the same time.) The display is updated every 30 seconds. The Tire pressure indicator (PSI) The tire pressure indicator shows tire pressure (0 - 51 psi) of all wheels (except the spare tire) by sending a signal from a sensor that is installed in each wheel. Press the trip computer setting B switch k to change the display to F (front) or R (rear). The tire pressure sensor will activate only when the vehicle is driven at speeds above 20 MPH (32 km/h). If the tire pressure signal cannot be received correctly, the display shows (----). The tire pressure indicator mode includes a low tire pressure warning feature. If the vehicle is being driven with low tire pressure*, the tire pressure indicator mode is automatically selected and the PSI indicator will blink in order to attract the driver's attention. Press the trip comA puter mode switch k if you wish to return to the mode that was selected before the warning occurred. The PSI indicator will continue blinking until the tire pressure of each tire is properly adjusted. Stopwatch (h:m:s) You can use the trip computer as a stopwatch. B Each time the trip computer setting switch k is pressed, the stopwatch will be operated as follows: After 100 hours, the time will start from the reset display again. 2-10 Instruments and controls