2009 Nissan cube Owner's Manual - Page 148

Fan speed control: Turn the fan speed control increase the fan speed. dial clockwise to position. 3. Turn the fan speed control desired position. dial to the . hot (right) position. To remove frost from the outside surface of the windshield quickly, turn the temperature control dial to the maximum hot position and the fan speed control dial to maximum (IIII) position. With air conditioner system: When the position is selected, the air conditioner will automatically turn on. This will dehumidify the air and help to defog the windows. The A/C indicator light will illuminate when the air conditioner automatically turns on. The air conditioner and A/C indicator light will remain on in all flow control modes until the A/C button is pressed or the fan control dial is turned to off. Turn the fan speed control dial counterclockwise to decrease the fan speed. A/C (Air Conditioner) operation (if so equipped): Push the A/C button to turn on or off the air conditioner. When the air conditioner is on, the A/C indicator light on the button illuminates. Temperature control: Turn the temperature control dial to set the desired temperature. Turn the dial between the middle and the right position (in red) to select the hot temperature. Turn the dial between the middle and the left position (in blue) to select the cool temperature. 4. Turn the temperature control dial to the desired position between the middle and the hot (right) position. Ventilation: This mode directs outside air to the side and center ventilators. 1. Push the air recirculation button to switch to the outside air circulation mode. (The indicator light turns off.) 2. Turn the air flow control dial to the position. 3. Turn the fan speed control desired position. Defrosting or defogging: This mode directs the air to the defroster outlets to defrost/defog the windows. 1. Turn the air flow control dial to the position. 2. Turn the fan speed control desired position. dial to the dial to the . Bi-level heating: This mode directs cool air from the side and center vents and warm air from the foot outlets. When the temperature control dial is turned to the maximum hot or cool position, the air between the ventilators and the foot outlets is the same temperature. 1. Push the air recirculation button to switch to the outside air circulation mode. (The indicator light turns off.) 2. Turn the air flow control dial to the position. Heater operation Heating: This mode is used to direct heated air to the foot outlets. 1. Push the air recirculation button to switch to the outside air circulation mode. (The indicator light turns off.) 2. Turn the air flow control dial to the 3. Turn the temperature control dial to the desired position between the middle and the 4-4 Heater, air conditioner, audio and phone systems