2009 Nissan cube Owner's Manual - Page 152

and 908F (328C). Air recirculation: button to change Push the air recirculation the air circulation mode. When the indicator light illuminates, the flowing air is recirculated inside the vehicle. Outside air circulation: Push the outside air circulation button to change the air circulation mode. When the indicator light illuminates, the flowing air is drawn from outside the vehicle. Automatic air intake control: To set the automatic control mode, perform one of the following operations. . When the outside air circulation mode is on, push and hold the outside air circulation button for more than 1.5 seconds. When the air recirculation mode is on, push and hold the air recirculation button for more than 1.5 seconds. SAA2368 OPERATING TIPS . When the engine coolant temperature and outside air temperature are low, the air flow from the foot outlets may not operate for a maximum of 150 seconds. This is not a malfunction. After the coolant temperature warms up, air will flow normally from the foot outlets. The automatic air conditioner (if so equipped) is equipped with sensors as A B illustrated. The sensors * and * on the instrument panel help maintain a constant temperature. Do not put anything on or around these sensors. . IN-CABIN MICROFILTER The air conditioning system is equipped with an in-cabin microfilter which collects dirt, pollen, dust, etc. To make sure the air conditioner heats, defogs, and ventilates efficiently, replace the filter according to the specified maintenance log shown in the NISSAN Service and Maintenance Guide. To replace the filter, contact a NISSAN dealer. The filter should be replaced if the air flow decreases significantly or if windows fog up easily when operating the heater or air conditioning system. SAA2369 . When setting the automatic control mode, both indicator lights will blink twice indicating that the system is in the automatic control mode. 4-8 Heater, air conditioner, audio and phone systems