2009 Nissan cube Owner's Manual - Page 162

The last station played will also come on when the PWR button is pushed to ON. Push the TUNE or or SEEK or button to adjust Bass, Treble, Fade and Balance to the desired level. Fade adjusts the sound level between the front and rear speakers and Balance adjusts the sound between the right and left speakers. Once you have adjusted the sound quality to the desired level, push the MENU button repeatedly until the radio or CD display reappears (normal mode). Otherwise, the radio or CD display will automatically reappear after approximately 10 seconds. For information about adjusting the clock display, see "CLOCK" in the "2. Instruments and controls" section. If another audio source is playing when the radio band select button is pushed, the audio source will automatically be turned off and the last radio station played will come on. When the stereo broadcast signal is weak, the radio will automatically change from stereo to monaural reception. TUNE (Tuning): Push the TUNE button tuning. SEEK tuning: Push the SEEK button or to tune from low to high or high to low frequencies and to stop at the next broadcasting station. SCAN tuning: Push the SCAN tuning button to tune from low to high frequencies and stops at each broadcasting station for 5 seconds. Pushing the button again during this 5 seconds period will stop SCAN tuning and the radio will remain tuned to that station. If the SCAN tuning button is not pushed within 5 seconds, SCAN tuning moves to the next or for manual station. to Station memory operations: Twelve stations can be set for the FM band (6 each for FM1 and FM2) and 6 stations can be set for the AM band. 1. Choose the radio band AM, FM1 or FM2 using the radio band select button. 2. Tune to the desired station using the SEEK, SCAN or TUNE button. 3. Select the desired station and push and hold the desired station preset buttons 1 to 6 until a beep sound is heard. (The radio mutes when the select button is pushed.) 4. The station indicator will then come on and the sound will resume. Memorizing is now complete. 5. Other buttons can be set in the same manner. If the battery cable is disconnected, or if the fuse blows, the radio memory will be erased. In that case, reset the desired stations. FM-AM radio operation Radio (FM/AM) band select: Pushing the radio band select button will change the band as follows: AM ? FM1 ? FM2 ? AM When the radio band select button is pushed while the ignition switch is in the ACC or ON position, the radio will come on at the station last played. Compact Disc (CD) player operation Place the ignition switch in the ACC or ON position, and insert the CD into the slot with the label side facing up. The CD will be guided automatically into the slot and start playing. 4-18 Heater, air conditioner, audio and phone systems