2009 Nissan cube Owner's Manual - Page 166
2009 Nissan cube Manual
Page 166 highlights
Audio main operation Head unit: The auto loudness circuit enhances the low and high frequency ranges automatically in both radio reception and CD playback. ON·OFF/Volume control: Place the ignition switch in the ACC or ON position, and then push the PWR button while the system is off to call up the normal mode (radio, CD, AUX and iPod) which was playing immediately before the system was turned off. While the system is on, pushing the PWR button turns the system off. Turn the VOL control knob to adjust the volume. MUTE button: Push the Push the setting. button to mute the audio sound. button again to release the mute Push the TUNE ( , ) or SEEK ( , ) button to adjust Bass and Treble to the desired level. Use the TUNE or SEEK button also to adjust Fade or Balance modes. Fade adjusts the sound level between the front and rear speakers and Balance adjusts the sound between the right and left speakers. To turn the beep sound off or on, push the TUNE or SEEK button until the desired mode is displayed. This turns on or off the beep sound when audio buttons are pushed. To change the Speed Sensitive Volume (Spd Sen Vol) mode to OFF, LOW, MID or HIGH, push the TUNE or SEEK button until the desired mode is displayed. Once you have adjusted the sound quality to the desired level, push the AUDIO button repeatedly until the normal mode display reappears. Otherwise, the normal mode display will automatically reappear after approximately 5 seconds. CLOCK button: Push the CLOCK button to turn on or off the CLOCK display. See "CLOCK" in the "2. Instruments and controls" section for the detailed clock adjustment operation. AUX (Auxiliary)/SAT radio band select: Pushing the AUX button will change between the auxiliary input and the XM Satellite Radio bands (if so equipped) as follows: XM1 ? XM2 ? XM3 ? AUX ? XM1 The satellite radio mode will be skipped unless an optional satellite receiver and antenna are installed and an XM Satellite Radio subscription is active. Satellite radio is not available in Alaska, Hawaii and Guam. If an AUX device is not connected, this mode will be skipped. See "Radio operation" later in this section for details about using this button for the satellite radio mode. See "AUX (Auxiliary) input" later in this section for details about using this button when connecting this audio system with AUX devices. AUDIO button: Push the AUDIO button to change the selecting mode as follows. Radio operation Radio (FM/AM) band select: Pushing the FM·AM radio band select button will change the band as follows: AM ? FM1 ? FM2 ? AM 4-22 Heater, air conditioner, audio and phone systems