2009 Nissan cube Owner's Manual - Page 301
2009 Nissan cube Manual
Page 301 highlights
¯ FOR Krom MODELS Use the following steps to mount the license plate: Before mounting the license plate, confirm that the following parts are enclosed in the vinyl bag...License plate bracket J-nut 6 2 Screw 6 4 Screw grommet 6 4 1. Park the vehicle on flat, level ground. 2. Temporarily place the license plate bracket A while aligning points * of the front bumper B fascia with holes * in the license plate bracket. A B 3. Confirm that points * and * are aligned. Hold the license plate bracket and mark the C points * on the bumper facia through the D center of the holes * with a felt-tip pen. 4. Remove the license plate bracket. A 5. Carefully drill two shallow pilot holes * C and * using a 0.39 in (10 mm) drill bit at the marked locations. (Be sure that the drill only goes through the fascia, or damage to the nut may occur.) STI0648 6. Insert grommets into the hole on the fascia. Technical and consumer information 9-13