2009 Nissan cube Owner's Manual - Page 167

When the stereo broadcast signal is weak, the radio will automatically change from stereo to monaural reception. When the radio band select button is pushed while the ignition switch is in the ACC or ON position, the radio will come on at the station last played. SAT radio band select: The last station played will also come on when the PWR button is pushed to ON. If another audio source is playing when the satellite radio band select button is turned to ON, the audio source will automatically be turned off and the last radio station played will come on. TUNE (Tuning): or for manual Push the TUNE button tuning. To move quickly through the stations, push and hold the TUNE button. SEEK tuning: . For AM and FM radio Push the SEEK button or to tune from low to high or high to low frequencies and to stop at the next broadcasting station. . For XM Satellite Radio (if so equipped) Push the SEEK button or to tune to the first channel of the next or previous category. SCAN tuning: heard. (The radio mutes when the radio station preset button is pushed.) 4. The station indicator will then come on and the sound will resume. Memorizing is now complete. 5. Other buttons can be set in the same manner. If the battery cable is disconnected, or if the fuse opens, the radio memory will be erased. In that case, reset the desired stations. Radio Data System (RDS): RDS stands for Radio Data System, and is a data information service transmitted by some radio stations on the FM band (not AM band) encoded within a regular radio broadcast. Currently, most RDS stations are in large cities, but many stations are now considering broadcasting RDS data. RDS can display: ...Station call sign, such as "WHFR 98.3". Station name, such as "The Groove". Music or programming type such as "Classical", "Country" or "Rock". Traffic reports about delays or construction. Push the SCAN button to tune from low to high frequencies and stops at each broadcasting station for 5 seconds. Pushing the button again during this 5 seconds period will stop SCAN tuning and the radio will remain tuned to that station. If the SCAN tuning button is not pushed within 5 seconds, SCAN tuning moves to the next station. to Station memory operations: Eighteen channels can be set for the SAT (if so equipped) band (6 each for XM1, XM2 and XM3), 12 stations can be set for the FM band (6 each for FM1 and FM2), and 6 can be set for the AM band for easy access. 1. Choose the radio band using the radio band select button. 2. Tune to the desired station using the SEEK, SCAN or TUNE button. 3. Push and hold the desired radio station preset button to until a beep sound is If the station broadcasts RDS information, the RDS icon is displayed. Heater, air conditioner, audio and phone systems 4-23