2013 Nissan cube Owner's Manual - Page 194
2013 Nissan cube Manual
Page 194 highlights
IC Regulatory information GUID-38417C85-F16D-4DFA-9E39-2AD07F3C270B . Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. This Class B digital apparatus meets all requirements of the Canadian InterferenceCausing Equipment Regulations. Operating tips GUID-74F3B4BB-101D-439B-9AA7-27E79FCD3289 To get the best performance out of the NISSAN Voice Recognition system, observe the following: . Keep the interior of the vehicle as quiet as possible. Close the windows to eliminate surrounding noises (traffic noises, vibration sounds, etc.), which may prevent the system from recognizing voice commands correctly. Wait until the tone sounds before speaking a command. Otherwise, the command will not be received properly. Start speaking a command within 5 seconds after the tone sounds. Speak in a natural voice without pausing between words. . . . . USING THE GUID-42FB520A-DDBD-4125-9AEE-F999C79449E7 SYSTEM The NISSAN Voice Recognition system allows hands-free operation of the Bluetooth® HandsFree Phone System. If the vehicle is in motion, some commands may not be available so full attention may be given to vehicle operation. . . . Initialization Giving voice GUID-DF45E2E1-C154-43BA-9F70-D3542450863A command To operate NISSAN Voice Recognition, push and release the button located on the steering wheel. After the tone sounds, speak a command. The command given is picked up by the microphone, and voice feedback is given when the command is accepted. . If you need to hear the available commands for the current menu again, say "Help" and the system will repeat them. . GUID-C0356C5D-ED63-4A07-9CF3-DC41E0534732 When the ignition switch is pushed to the ON position, NISSAN Voice Recognition is initialized, which takes a few seconds. If the button is pushed before the initialization completes, the system will not accept any command. . . If a command is not recognized, the system announces, "Command not recognized. Please say again." Repeat the command in a clear voice. If you want to go back to the previous command, you can say "Go back" or "Correction" anytime the system is waiting for a response. You can cancel a command when the system is waiting for a response by saying, "Cancel" or "Quit." The system announces "Cancel" and ends the VR session. You can also push and hold the button for 5 seconds on the steering wheel at any time to cancel the VR session. Whenever the VR session is cancelled, a double beep is played to indicate you have exited the system. If you want to adjust the volume of the voice feedback, push the volume control switch (+ or −) on the steering wheel while being provided with feedback. You can also use the radio volume control knob. In most cases you can interrupt the voice feedback to speak the next command by pressing the button on the steering wheel. To use the system faster, you may speak the second level commands with the main menu 4-52 Center display, heater, air conditioner, audio and phone systems