2013 Nissan cube Owner's Manual - Page 220

WARNING Apply the parking brake if the selector lever is in any position while the engine is not running. Failure to do so could cause the vehicle to move unexpectedly or roll away and result in serious personal injury or property damage. If the ignition switch is placed in the OFF or ACC position for any reason while the selector lever is in any positions other than the P (Park), the ignition switch cannot be placed in the LOCK position. If the ignition switch cannot be placed in the LOCK position, perform the following steps: 1. Apply the parking brake when the vehicle is stopped. 2. Place the ignition switch in the ON position while depressing the foot brake pedal. 3. Move the selector lever to the P (Park) position. 4. Models with Intelligent Key system: Place the ignition switch in the OFF position. Models without Intelligent Key system: Place the ignition switch in the LOCK position. CAUTION To prevent transmission damage, move the selector lever to the P (Park) or R (Reverse) position only when the vehicle is completely stopped. P (Park): GUID-D73A39BF-43C8-459F-9C24-47B7F579C407 Use this selector position when the vehicle is parked or when starting the engine. Make sure the vehicle is completely stopped. The brake pedal must be depressed and the selector lever button pushed in to move the selector lever from N (Neutral) or any drive position to P (Park). Apply the parking brake. When parking on a hill, apply the parking brake first, then move the selector lever to the P (Park) position. R (Reverse): GUID-D73A39BF-43C8-459F-9C24-47B7F579C407 Use this position to back up. Make sure the vehicle is completely stopped before selecting the R (Reverse) position. The brake pedal must be depressed and the selector lever button pushed in to move the selector lever from P (Park), N (Neutral) or any driving position to R (Reverse). SSD0862 To move the selector lever, : : : Push the button A while depressing the brake pedal. Push the button A . Just move the selector lever. * * Shifting GUID-12C8B6BA-1A20-43EC-BA4A-3CF7FF6C789E After starting the engine, fully depress the brake pedal, push the selector lever button and move the selector lever from the P (Park) position to any of the desired shift positions. 5-16 Starting and driving