2013 Nissan cube Owner's Manual - Page 313
2013 Nissan cube Manual
Page 313 highlights
INSTALLING FRONT LICENSE PLATE GUID-5D0CEAD0-4D42-4678-963C-AFB3A011E8CC Use the following steps to mount the license plate: Before mounting the license plate, confirm that the following parts are enclosed in the plastic bag...1. License plate bracket J-nut 6 2 Screw 6 2 Screw grommet 6 2 Park the vehicle on flat, level ground. A on the lower 2. Locate the center position * part of the air duct. Measure straight down from the edge where the bumper and air B , keeping duct meet to the aligning holes * the tape measure lined up with the center position. 3. Mark the holes B * with a felt-tip pen. B 4. Carefully drill the two aligning holes * using a 0.39 in (10 mm) drill bit at the marked locations. (Be sure that the drill only goes through the bumper fascia.) C 5. Line up the bosses * or license plate bracket with the holes and hold the license plate bracket in place. STI0647 6. Mark the center of the holes tip pen. D * with a felt- Technical and consumer information 9-11