1996 Oldsmobile Silhouette Owner's Manual - Page 81
1996 Oldsmobile Silhouette Manual
Page 81 highlights
Resetting the rower diding Door The power sliding door may operate incorrectly or not all because of the following conditions: 0 0 A low voltage or dead battery Disconnecting the battery 0 If the GUAGES, TAIL or TURN B/U fuse is removed or blown. See "Fuse Panel" in the Index for more information about your fuse panel. If any of these conditions occur, the power sliding door will need to be reset. To do this, follow the directions listed here. It will be easier if you read through them once before beginning this procedure. To manually close the power sliding door when the sliding door ON/OFF switch is in the ON position, pull the inside or outside latch release or the edge of the door. Move the door about 4 inches (10 cm)toward the closed position and release. The door will close completely and latch foryou. To manually close the power sliding door when the ON/OFF switch is in the OFF position, pull the inside or outside latch release and slide the door all the way forward to the latch position. 1 . Check to be sure the power sliding door is unlocked and securely closed. 2. Turn the ignition switch to the OFF position. 3. Turn the power sliding door ON/OFF switch to OFF. 4. Remove the TAIL fuse from the fuse panel. Leave it out for 30 seconds. 5 . Reinstall the fuse and wait 10 seconds. 6. Move the ON/OFF switch to the ON position. 2-