1997 Pontiac Trans Sport Owner's Manual - Page 120

See "Fuse Panel" in the Index more information for about yourfuse panel. If any of these conditions occur, the power sliding door someone. To make sure the door does not slam will need tobe reset. To do this, follow the directions shut, enable the power sliding door feature. Then listed here.It will be easier you read through them if if the door closes, it will close under the control of once before beginning this procedure. the power door system. 1. Check tobe sure the power sliding door unlocked is and securely closed. To manually close the power sliding door when the 2. Turn the ignition switch to the position. OFF override feature is disabled, pull the inside or outside latch 3. Enable the power sliding door override feature. 4 release or the edge of the door. Move the door about inches (10 cm) toward the closed position and release. The 4. Remove the RADIO fuse from the underhoodfuse door will close completely and latch for you. and relay center. Leave out for30 seconds. it To manually close the power sliding door when the 5. Reinstall the fuse and wait10 seconds. override featureis enabled, pull the inside or outside latch release and slide the door all the way forward to 6. Disable the power sliding door override feature. the latch position. 7. Push eitherof the power door buttons to open the power sliding door. Resetting the Power Sliding Door 8. Wait five seconds and close the door by pushing The power sliding door may operate incorrectly not or either power door button. all becauseof the following conditions: 7 9. Wait five seconds and repeat Steps and 8. e A low voltage or dead battery, If the door does not rest in the fully open position after Disconnecting the battery or repeating Step 7, repeat Steps 7 and 8 again. If the door If tEe IGN 1, B/U LAMP, RADIO or PWR still does not operate correctly, see your dealer for service. SEATFSD fuse is removed or blown. 2-19