2003 Pontiac Bonneville Owner's Manual - Page 138
2003 Pontiac Bonneville Manual
Page 138 highlights
If you can't see the HUD image when the ignition is on, check to see if: 0 0 0 The HUD unit is covered, the HUD INTENSITY knob is adjusted correctly, the HUD image is adjusted to the proper height, or a fuse in the fuse panel may have blown. See Fuses and Circuit Breakers on page 5-92. To use the outlet, remove the protective cap which covers it. When not using it, always cover the outlet with the protective cap. The accessory power outlet will only operate when the ignition key is in ON and for 10 minutes after turning the ignition OFF. If you would like the accessory power outlet to operate regardless of ignition position, and for extended periods of time, see "Engine Compartment Fuse Block" under Fuses and Circuit Breakers on page 5-92 or see your dealer for more information. Nofice: When using an accessory power outlet, maximum electrical load must not exceed 15 amps. Always turn off any electrical equipment when not in use. Leaving electrical equipment on for extended periods will drain your battery. Certain electrical accessories may not be compatible with the accessory power outlet and could result in blown vehicle or adapter fuses. If you experience a problem, see your dealer for additional information on accessory power outlets. If the HUD image is not clear, it could be too bright. Move the HUD INTENSITY knob counterclockwise. You may need to clean the windshield and HUD lens. Your windshield is part of the HUD system. If you ever have to have a new windshield, be sure to get one designed for HUD. If you don't, the HUD image may look blurred and out of focus. Accessory Power Outlets If your vehicle has a front console, the accessory power outlet (12-volt ) is located at the rear of the front console. If your vehicle has a floor console, the outlet is located at the rear of the floor console. 3-23