2003 Pontiac Bonneville Owner's Manual - Page 188

Set the volume at the desired level. Press this button to select MIN, MED or MAX. Each higher choice allows for more volume compensation at faster vehicle speeds. Then, as you drive, SCV automatically increases the volume, as necessary, to overcome noise at any speed. The volume level should always sound the same to you as you drive. If you don't want to use SCV, select OFF. RCL (Recall): Push this knob to switch the display between the radio station frequency and the time. Pushing this knob with the ignition off will display the time. For XMTM(USA only, if your radio is equipped with XMTMSatellite Radio Service), pressing this button while in XMTM mode retrieve various pieces of information to related to the current song or channel. By pressing and releasing the RCL knob, you may retrieve four different categories of information: Artist, Song Title, Category or PTY, Channel Number/ Cnannei hame. Finding a Station BAND: Press this button to switch between AM, FM, FM2, or XMI, XM2 (USA only, if your radio is equipped with XMTMSatellite Radio Service). The display will show your selection. TUNE: Turn this knob to choose radio stations. SEEK : Press the up or the down arrow to go to the next or to the previous station and stay there. The radio will seek only to stations that are in the selected band and only to those with a strong signal. SCAN : Press and hold one of the SCAN arrows for two seconds until SCAN appears on the display and you hear a beep. The radio will go to a station, play for a few seconds, then go on to the next station. Press one of the SCAN arrows again to stop scanning. To scan preset stations, press and hold one of the SCAN arrows for more man Tour seconas uniii FSGAi< and the preset number appear on the display. You will hear a double beep. The radio will go to the first preset station stored on your pushbuttons, play for a few seconds, then go on to the next preset station. Press one of the SCAN arrows again to stop scanning presets. The radio will scan only to stations that are in the selected band and only to those with a strong signal. 3-73 A v v To change the default on the display, push the knob until you see the display you want, then hold the knob until the display flashes. The selected display will now be the default.