2013 Subaru Impreza Owner's Manual - Page 124

3-6 Instruments and controls & Canceling the function for meter/gauge needle movement upon turning on the ignition switch It is possible to activate or deactivate the movement of the meter needles and gauge needles that takes place when the ignition switch is turned to the "ON" position. To change the setting, perform the following procedure. 1. Turn the ignition switch to the "LOCK" or "ACC" position. trip knob. & Odometer *: They cannot be displayed when the ignition switch is in the "ON" position. To change the current setting, press the trip knob for at least 2 seconds. : Activated : Deactivated 1) Trip knob NOTE . Your vehicle 's initial movement setting of the meter/gauge needles has been set for activation " " at the time of shipment from the factory. . It is not possible to change the initial movement setting of the meter/gauge needles when the ignition switch is in the "ON" position. Change the setting when the ignition switch is in the "LOCK" or "ACC" position. " or This meter displays the odometer when the ignition switch is in the "ON" position. The odometer shows the total distance that the vehicle has been driven. If you press the trip knob when the ignition switch is in the "LOCK" or "ACC" position, the odometer/trip meter will light up. If you do not press the trip knob within 10 seconds of illumination of the odometer/ trip meter, the odometer/trip meter will turn off. Also, if you open and close the driver 's door within 10 seconds of illumination of the odometer/trip meter, the odometer/trip meter will turn off. 1) Trip knob 2. Press the trip knob to show " " " on the trip meter display. & Speedometer The speedometer shows the vehicle speed. The display can be switched as shown in the following sequence by pressing the