2013 Subaru Impreza Owner's Manual - Page 408

11-38 NOTE Maintenance and service . If headlight aiming is required, consult your SUBARU dealer for proper adjustment of the headlight aim. . It may be difficult to replace the bulbs. Have the bulbs replaced by your SUBARU dealer if necessary. Perform the following steps to replace the bulbs. 1) 2) Low beam bulb High beam bulb Right-hand side 1. Use a screwdriver to undo the clips on the air intake duct, then remove the air intake duct (right-hand side). Left-hand side 2. Use a screwdriver to remove the secured clip of the washer tank. To make it easy to access the bulb, turn the neck of the washer fluid filler pipe as illustrated (left-hand side). 3. Disconnect the electrical connector from the bulb and remove the bulb from the headlight assembly by turning it counterclockwise. 4. Replace the bulb with new one. At this time, use care not to touch the bulb surface. 5. To install the bulb to the headlight assembly, turn it clockwise until it clicks. 6. Reconnect the electrical connector. 7. Install the air intake duct with clips (right-hand side). 8. Set the washer fluid filler pipe to the original place and secure it by clip (lefthand side).