2013 Subaru Impreza Owner's Manual - Page 207

Climate control 4-7 Automatic climate control operation (type B, C and D) When this mode is selected, the fan speed, airflow distribution, air-inlet control, and air conditioner compressor operation are automatically controlled. To activate this mode, perform the following. the AUTO mode is controlled automatically. Any function not set to the AUTO mode can be manually adjusted as desired. . The controllable temperature range may vary depending on the regional specifications of the vehicle. 3. To turn off the climate control system, turn the fan speed control dial to the "OFF" position. NOTE . Operate the automatic climate control system when the engine is running. . Even when cooling is not necessary, setting the temperature much lower than the current outlet air temperature turns on the air conditioner compressor automatically and the "A/C" indicator light on the control panel illuminates. & Type C and D 1. Depress the " AUTO " button. The indicator light "FULL AUTO" on the display illuminates. 2. Set the preferred temperature using the temperature control dial. . If you operate any of the buttons on the control panel other than the "OFF" button, rear window defogger button and temperature control dial(s) during FULL AUTO mode operation, the "FULL" indicator light on the control panel will turn off and the "AUTO" indicator light will remain illuminated. You can then manually control the system as desired using the button you operated. To change the system back to the FULL AUTO mode, press the "AUTO" button. 3. To turn off the climate control system, press the "OFF" button. NOTE . For type D, when the "DUAL" mode button is pressed, separate temperature settings for the driver 's side and passenger 's side can be enabled (DUAL mode). To cancel the DUAL mode, press the "DUAL" mode button again. The temperature setting for the passenger 's side becomes the same as the setting for the driver 's side. . The controllable temperature range may vary depending on the regional specifications of the vehicle. - CONTINUED - & Type B 1. Turn the airflow mode selection dial and fan speed control dial to the "AUTO" position. 2. Set the preferred temperature using the temperature control dial. NOTE . Each function can be individually set to the AUTO mode independently of the other functions. Any function set to