2013 Subaru Impreza Owner's Manual - Page 56

1-30 Seat, seatbelt and SRS airbags position to be safe. For details, refer to "Where to place a child restraint system" F1-26. 4. Run the lap and shoulder belt through or around the child restraint system following the instructions provided by its manufacturer. - When a child restraint system is installed on the rear center seating position of a 5-door model, pass the rear center seatbelt through the belt guide properly. For details, refer to "Rear center seatbelt on 5-door models" F1-17. 5. Insert the tongue plate into the buckle until you hear a click. 6. Take up the slack in the lap belt. 7. Pull out the seatbelt fully from the retractor to change the retractor over from the Emergency Locking Retractor (ELR) to the Automatic Locking Retractor (ALR) function. Then, allow the belt to rewind into the retractor. As the belt is rewinding, clicks will be heard which indicate the retractor functions as ALR. 8. Before having a child sit in the child restraint system, try to move it back and forth and right and left to check if it is firmly secured. Sometimes a child restraint can be more firmly secured by pushing it down into the seat cushion and then tightening the seatbelt. 9. Pull at the shoulder portion of the belt to confirm that it cannot be pulled out (ALR properly functioning). 10. Latch the top tether hook onto the tether anchorage that is located behind the rear seat and tighten the top tether firmly. For additional instructions, refer to "Top tether anchorages" F1-35.