2013 Subaru Impreza Owner's Manual - Page 145

Instruments and controls 3-27 ! Turn off display of driving information display The driving information display can be turned off. To turn off the display, turn the ignition switch to the "LOCK" position and press the "+" button adjacent to the clock display for approximately 5 seconds. Then, the driving information display and the clock display will blink for 3 seconds to notify you that the driving information display has been turned off. To restore the driving information display, once again press the "+ " button for approximately 5 seconds. & Clock 3. While the clock display is flashing, press and hold the "+" button for approximately 2 seconds. The clock format will then change. 4. The clock display will continue to flash for approximately 3 seconds to inform you that the clock display has been changed. If you want to change the clock display again, press and hold the "+" button for approximately 2 seconds while the clock display is flashing. NOTE . The initial display setting of the driving information display has been set to operational at the time of shipment from the factory. . The average fuel consumption and average vehicle speed are calculated even while the driving information display is not displayed. . Even if you turn off the driving information display, the display will automatically turn on when the battery voltage is disconnected and then reconnected for battery replacement or fuse replacement. To adjust the time shown by the clock, press the "+" button or "−" button. If you press the "+" button, the indicated time will change in one-minute increments. If you press the "−" button, the indicated time will change in one-minute decrements. If you keep the button pressed, the rate at which the indicated time changes will speed up. The clock can be set to 12-hour or 24-hour clock displays. Perform the following procedure to switch the display format. 1. Place the ignition switch in the "LOCK" position. 2. Press and hold the "−" button that is located near the clock display for approximately 5 seconds. The clock display will then start to flash.