3Com 5500-EI Getting Started Guide - Page 34
Switch 5500 and Switch 5500G-EI (PoE), Distance from Front to Rear, Mounting Positions
UPC - 662705498997
View all 3Com 5500-EI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
34 CHAPTER 2: INSTALLING THE SWITCH Switch 5500 and To rack-mount the front of your Switch 5500 and Switch 5500G-EI (PoE): Switch 5500G-EI (PoE) 1 Place the switch the right way up on a hard flat surface, with the front facing towards you. 2 Place a securing bracket over the mounting holes on one side of the front of the switch, as shown in Figure 15. 3 Insert the two screws and tighten them with a suitable screwdriver. 4 Repeat steps 1 and 2 for the other front securing bracket. You must use the screws supplied with the securing brackets. Damage caused to the unit by using incorrect screws invalidates your warranty. 5 Insert the switch into the 19-inch rack and secure with suitable screws (not provided). Ensure that the ventilation holes are not obstructed. To rack mount the rear of your switch: 1 Place a rear rail bracket over the mounting holes on one side of the rear of the switch, as shown in Figure 16. The bracket has two mounting positions. The one you choose depends on the rack depth. Table 12 describes the correct positions on which to mount the bracket: Table 12 Rear rail bracket mounting points Distance from Front to Rear 37cm - 25cm 43cm - 56cm Mounting Positions Middle mounting point Rear mounting point 2 Insert the screw and tighten it with a suitable screwdriver. 3 Repeat steps 1 and 2 for the other rear securing bracket.