3Com 5500-EI Getting Started Guide - Page 42
Installing and Removing the Power Module, Installing the Power Module, Module - configuration guide
UPC - 662705498997
View all 3Com 5500-EI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
42 CHAPTER 2: INSTALLING THE SWITCH The Switch 5500 supports 3Com 802.3af equipment. For the latest list of supported devices, refer to the product page on the 3Com web site at http://www.3com.com/ For additional information on Power over Ethernet, refer to the Power over Ethernet Configuration chapter in the Configuration Guide available on the 3Com Web site. Power over Ethernet management is available using the web interface or the command line interface (CLI). Installing and Removing the Power Module Installing the Power The Switch 5500G Family Power Module is swappable. To install the Module power module: 1 Wear an ESD wrist strip, and make that sure it is well grounded. 2 Verify that the Power Module is not installed upside-down (the module should be installed according to the letters. If the module is installed upside down, it will not be fully seated due the design of the chassis' internal structure). 3 Use one hand to hold the handle on the front, and another to hold the bottom. Slide it gently along the power slot. Push the module until it is fully seated. 4 Use a Phillips screwdriver to fasten the screws at both sides of the module. Removing the Power To remove the Power Module: Module 1 Wear an ESD wrist strip, and make sure it is well grounded. 2 Disconnect all power to the switch. 3 Use a Phillips screwdriver to unscrew the screws on both sides of the module. 4 Use one hand to hold the handle on the front, and another to hold the top. Pull out the module stably towards you along the power slot until it is completely apart from the chassis bottom.