3Com WX2200 Hardware Installation Guide - Page 41

Connecting to the Network 41 MAP LED Appearance Solid green Alternating green and amber Solid amber Blinking amber Unlit Meaning For a MAP access point's active link, with PoE enabled, all the following are true: „ MAP access point has booted. „ MAP access point has received a valid configuration from the WX switch. „ Management link with a MAP access point is operational. For a MAP access point's secondary link, the link is present. MAP access point is booting with an image received from the WX switch. PoE is on, but no MAP access point is connected to the link. MAP access point is unresponsive or there is a PoE problem. PoE is off. 3 If the cable is attached to a wired end station that uses AAA through the WX switch to access the network: „ For a first-time installation, set the port type to activate the link. (For information, see "Setting a Port for a Wired Authentication User" in the Wireless LAN Switch and Controller Configuration Guide.) „ If the port type is already set for a wired authentication port, go on to step 4. 4 If the cable is directly attached to a device other than a MAP access point: a Observe the appearance of the Link LED for the port: Link LED Appearance Solid green Solid amber Blinking green Blinking amber Unlit Meaning 100-Mbps link is operational. 10-Mbps link is operational. Traffic is active on the 100-Mbps link. Traffic is active on the 10-Mbps link. Link is not operational. b If the Link LED is unlit, check the cable and verify that the device at the other end of the link is operating.