3Com WX2200 Hardware Installation Guide - Page 43
If the LED is unlit, the link is not operational. Check the cable and, If the LED is blinking amber
UPC - 662705511191
View all 3Com WX2200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
Connecting to the Network 43 Figure 14 GBIC Removal from a WX4400 Switch Squeeze the lock clips to release GBIC. To install a GBIC: 1 Insert the GBIC into a GBIC slot on the front panel until it clicks into place. 2 Remove the protective covering(s) from the port connector(s) and set them aside in a safe place for later use. 3 Insert the network cable. For 1000BASE-SX or 1000BASE-LX fiber, make sure you insert the two cable ends in the proper sides (transmit or receive). Otherwise, the link does not work. 4 Observe the upper LED to the right of the GBIC port: If the LED is green, the 1000-Mbps link is operational. If the LED is blinking amber, traffic is active on the 1000-Mbps link. If the LED is unlit, the link is not operational. Check the cable and verify that the device at the other end of the link is operational. To remove a GBIC: 1 Remove the network cable(s). 2 Insert the protective covering(s) into the port connector(s). 3 Squeeze the clips on the sides of the GBIC and pull the GBIC out of the slot.