3M M1700SS User Guide - Page 11
Setting Up Your M1700SS Display - usb
UPC - 511199609764
View all 3M M1700SS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
3M™ MicroTouch™ Display M1700SS User Guide 11 CHAPTER 2 Setting Up Your M1700SS Display This chapter describes how to set up and integrate your 3M TM MicroTouchTM M1700SS Display into a touch application system. You need to complete the following tasks: • Unpack the components • Connect the video and power cables to your computer • Power on the display and test your setup • Install the touch software then connect the touch sensor cable • Calibrate the touch sensor System Requirements The M1700SS Display requires a personal computer (PC). This display will not work with Apple Macintosh computers. The requirements for your PC are as follows: • Your PC must have an available RS-232 serial communication (COM) port or USB port. You connect the touch sensor to this port. • Your PC must have a video card and video driver already installed for the display. If you need to install a video card or a video driver, refer to your computer documentation for instructions. • Your PC must have a unique interrupt request (IRQ) available to the touch sensor COM port. The touch sensor cannot share an IRQ with another device. When choosing your workspace, select a sturdy, level surface. Also, make sure you can easily access the back of the display and the computer. Easy access helps ensure a smooth setup of the M1700SS Display. Note: Before setting up your M1700SS Display, refer to the Important Safety Information section at the beginning of this document.