Arlo Wire-Free User Manual - Page 8
Arlo Base Station LEDs, Get an Account, Enable Touch ID
View all Arlo Wire-Free manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Set Up Your System The Power LED and Internet LED light green in about two minutes. Reset SYNC DC Ethernet Your base station is set up. Arlo Base Station LEDs See the following list of explanations for green, amber, and blinking LEDs: Power Green The base station is powered on. Blinking green A firmware update is in progress. DO NOT TURN OFF THE BASE STATION OR CAMERAS. Amber The base station is booting. Off The base station is powered off. Internet Green The base station is connected to the Internet. Blinking green The base station is sending data over the Internet. Amber The base station is connected to the router but did not get an Internet connection. Off The base station is not connected to your router. Camera Green Cameras are connected to the base station. Blinking green The base station is attempting to sync with a camera. Blinking amber A camera is too far from the base station. Signal strength is weak. Off No cameras are detected. Get an Account ¾¾ To set up an Arlo account: 1. Tap the Arlo icon on your mobile device. If you are using a computer, enter arlo.netgear.com in the address bar of a browser. If you are using a mobile device that supports a Touch ID® fingerprint identity sensor, you are prompted to enable Touch ID or skip. 2. To use Touch ID, tap Enable Touch ID. 8