Behringer DEEPMIND 6 Manual - Page 36
WRITE Write Menu, Renaming Programs
View all Behringer DEEPMIND 6 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
36 DeepMind 6 User Manual 7.5 WRITE (Write Menu) 1. To write a program to memory, first press the WRITE switch. 2. The WRITE PROGRAM menu will then appear: 8. To compare the current program with the intended program location, you can press the COMPARE switch to listen to the difference. To return to the current program, press the COMPARE switch again. 9. Once you have selected the new location and named the program, press the WRITE switch again to write the program. At any time you decide not to write the program, press the PROG switch to return to the main programming display. Note: If there is a program in the backup memory (such as an unsaved edited program), then you will see the message "COMPARE: Clear Backup". 3. In this menu you can use the -/NO or +/YES switches to navigate through the sections. The selected section will be highlighted by an inverted character (white on black). 4. The first section is the program location where the current program will be saved. You can use the BANK/UP, BANK/DOWN switches, the rotary knob, or the DATA ENTRY fader to select the required BANK (A-H) and PROGRAM NUMBER (1-128). Be careful that you do not overwrite an existing program you would rather keep. 5. The second section is the "CATEGORY" where you can select any of the available program categories. Again you can use the BANK/UP, BANK/DOWN switches, the rotary knob, or the fader to select the required category. 6. The third section is "TO BE REPLACED BY" which shows the name of the program to be written. If you want to change the name, you can use the -/NO or +/YES switches to step through each character of the name and use the BANK/UP, BANK/DOWN switches, the rotary knob, or the faders to change the character. 10. If you wish to listen to the intended program location as described earlier, you will need to press the COMPARE switch to first clear the backup memory. Once the backup has been cleared then the message will revert to "COMPARE: Listen" and you can listen to the intended program location as normal. 7.6 Renaming Programs 1. To rename an existing program, follow the procedure above for writing a program, keep the BANK and PROGRAM NUMBER the same, and then change the name shown in the "TO BE REPLACED BY" section. 7. There are also two short-cuts for selecting characters, indicated by text in bottom of the display, just above the FX and GLOBAL switches. Note: These two short-cuts will only appear when you are editing the name of the TO BE REPLACED BY program. a-A-0 - Press the FX switch to cycle between lower-case, upper-case, and numbers/special characters. DEL - Press the GLOBAL switch to delete the currently selected character.