Behringer DEEPMIND 6 Manual - Page 66
Osc 2 Pitch Fader, Osc 2 Level Fader
View all Behringer DEEPMIND 6 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 66 highlights
66 DeepMind 6 User Manual 8.3.7 OSC 2 PITCH FADER 8.3.8 OSC 2 LEVEL FADER • The OSC 2 PITCH fader controls the PITCH of the OSC 2 SQUARE waveform, • The OSC 2 LEVEL fader controls the LEVEL of the OSC 2 SQUARE waveform. relative to the pitch of OSC1 (which is set by the keys that you play on the The level setting can be used to adjust the balance between OSC 1 and OSC 2. keyboard). The pitch can be tuned to match the pitch of OSC1, or offset slightly to create a wider sound, or offset more to create harmonic overtones. OSC 2 LEVEL As you increase/decrease the PITCH fader, the pitch of the oscillator will increase/decrease. 0 (KEY PITCH) OSC 2 PITCH 0FF -12.0 dB 0.0 dB -12 SEMITONES +12 SEMITONES The OSC 2 PITCH range is from -12.0 semitones to +12.0 semitones. The default OSC 2 PITCH setting is 0 semitones (= OSC 1). The fader position, current value, and stored value for the OSC 2 PITCH fader is shown on the PROG screen. There is also a visualization of the pitch setting as shown below: The balance between OSC 1 and OSC 2 when used together, allows you to increase the sonic palette of the program. Combining oscillators can be done to create new waveforms and alter the harmonic structure of the program. By slightly detuning the oscillators, you can create bigger, thicker sounds. Detuning in small and equal increments will not make a noticeable difference to the base pitch of the sound, but as you increase the amount of detuning it will start to become noticeable. Detuning can be done in musical intervals for example a fifth, or a seventh, to add harmony to a pad sound, or even an entire octave to give a bass program a deeper sound. The OSC 2 LEVEL can be set to Off, or its operational range is from -48 to 0.0 dB. The default OSC 2 LEVEL setting is 0ff. The fader position, current value, and stored value for the OSC 2 LEVEL fader is shown on the PROG screen. There is also a visualization of the waveform as shown below. Note: It is important to note that the visualization shows the combination of OSC 1 and OSC 2. Note: The centre horizontal section of the line shown in the visualization, highlights the fine resolution that is available around the centre point. Here the units of adjustment will change from semitones to cents, giving you fine adjustment when close to the pitch of OSC1.