Bosch HBL8651UC Instructions for Use - Page 17

3. The Set Probe Temp screen is displayed. A three digit input prompt "- - -" blinks in the lower right corner. Use the numeric keypad to enter the desired probe temperature and press Enter on the numeric keypad. 4. Set the cooking mode and temperature. Note: The minimum probe temperature that can be set is 100° F (40° C) and the maximum is 200° F (100° C). If the probe temperature entered is outside this range, an error is displayed. • To change the probe temperature press the Probe touchpad. The display enters probe temperature editing mode and displays the message "SET PROBE TEMP". Enter the new probe temperature and press Enter to accept the new value. • Do not store the probe in the oven. • Always use the handle of the probe for inserting and removing. • Always use a potholder to remove the probe since it becomes hot. • The probe is only available for the upper oven in double oven units. Sabbath Mode 5. The probe current temperature and target temperature are both displayed in the format "105 / 180" at the lower right corner of the display. The displayed probe temperature is updated in increments of 5° during the cooking process. 6. When the probe temperature reaches the set temperature, the cooking mode turns off. The current time is displayed and the message "COOKING COMPLETE" blinks at the bottom left of the display. An alarm tone sounds every 10 seconds for 2 minutes. The Sabbath mode enables those of particular faiths to use their ovens on the Sabbath. The Sabbath mode can be entered in a Bake mode only. The bake temperature must be within the Sabbath mode temperature range of 100° to 450° F. If the oven light is on during setup, it remains on throughout the Sabbath mode operation. If the oven light is off during setup, it remains off throughout the Sabbath mode operation. To set the Sabbath Mode: No kitchen timers or oven timers may be running when Sabbath mode is entered. 1. Begin a Bake operation. While Bake is running, press and hold the Oven Timer touchpad for five seconds. If a timer is running when Sabbath mode attempts to start, the display blinks the message: "SABBATH NOT AVAILABLE". This screen remains in the display until it is cleared by pressing the Oven Clear/Off touchpad or until the probe is removed. The display then goes back to stand by mode. Note: • Probe is not available when an Oven Timer or Delay Cook mode (in upper oven, for a double oven) has been set. If no timers are running, the Sabbath mode settings appear in the display. The Sabbath Mode timer blinks showing the value can be edited. The default value is 74:00 (the maximum number of hours for which Sabbath Mode can be set.) English 15