Bosch WTVC6330US User Manual - Page 9

q After making preliminary adjustments, press down on each corner of the dryer to make sure the unit does not wobble. If pressing down on a corner causes the dryer to wobble, lower the dryer foot on that corner until the foot touches the floor firmly. Install the dryer and level it from side to side and front to back. Use a bubble level. Never remove the heightĆadjustable feet! 13. Connect the exhaust duct to the exhaust air outlet on the dryer (see page 17). 14. Insert the dryer electrical plug into the wall receptacle (see page 14). 15. Read the operating instructions to understand how your dryer operates. (see page 20). 16. Conduct an appliance test: q Check that the drum is empty. q Close the dryer door. q Switch the dryer to "Extra Dry" and then press the Start/Pause" button. q After 3-5 minutes press the Start/Pause" button and open the door. q If the interior of the dryer feels warm, the dryer has been connected properly. Switch the dryer to "OFF". q If the dryer does not work, switch the dryer to "OFF". Look in the troubleshooting section (page 30) and find the fault. Door Hinge Reversal The door is hinged on the right hand side of the dryer at the factory. The door hinge can be reversed if necessary. Tools Needed T20 star head screwdriver Hinge Reversal Parts Hinge (with 4 white plastic bushings) Hinge Cover Plate Door Assembly Hinge Reversal Procedure 1. Unplug the dryer. 2. Prepare a firm, flat, padded surface to lay the dryer door on while changing the hinge. 3. Open the dryer door to fully expose the hinge cover. 4. Remove the 4 screws holding the hinge cover in place. remove four screws Set the cover aside along with the four screws for later reinstallation. 5. Rotate the door so that it is perpendicular to the dryer front. Slide the door away from the dryer so the hinge pins slide out of the grooves in the dryer door. check to make sure that all four plastic bushings remain on the hinge pins Avoid allowing the 4 plastic bushings to fall off the hinge pins. If any of the bushings do fall off, reinstall them on the hinge pins prior to reinstalling the door. 6. Lay the dryer door face down on a firm, flat, padded surface, with the bottom of the door facing towards you. 7. Remove the two screws holding the striker cover plate in place. Hold the striker while lifting the cover so as to keep the parts together in place and set the assembly aside for later reinstallation. striker 8. Remove the single screw that was hidden by the striker plate cover. 9