Bowflex Ultimate Assembly and Owners Manual - Page 104
V, W, X, Y, Z
View all Bowflex Ultimate manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 104 highlights
A-16 Assembling Your Bowflex® Ultimate™ Leg Assembly Step 5: INSTALLING THE LEG EXTENSION ATTACHMENT Place the leg extension on the end of the rail and tighten the two small star knobs (Item #68) through the sides of the leg extension rail bracket and into the rail as shown in Figure V. Make sure that the leg extension does not interfere with the rear leg, and if it does interfere, check to make sure the rear leg is mounted 1/2" to 1" from the end of the seat rail. Take the leg attachment cables and snap them into the cable storage clips on the bracket under the seat rail. Unit appears like this following this assembly step (shown with optional lat tower) 68 Figure V BEFORE EACH USE OF THE EQUIPMENT, CHECK ALL FASTENERS, SNAP HOOKS, CABLES AND PULLEY FUNCTIONS. TIGHTEN AND FASTEN AS NEEDED. CHECK PULLEYS AND CABLES FOR WEAR AND FUNCTION. ASSEMBLING YOUR Bowflex® T-BAR Your T-bar was shipped fully assembled with the metal bar resting in the loops of the nylon strap. If, however, the bar and the nylon strap separated during shipping, follow these instructions for reassembly. The nylon strap has one flat side and one side with several twists. Lay the nylon strap on a flat surface with the flat side down, as shown in Figure W. L ift the strap by the metal rings and hold it in front of you. Turn the strap completely over with the twisted side down. Grab the strap in the center with the index finger of one hand. See Figure X. Use your index finger and thumb of your free hand to spread the strap into two loops, as shown in Figure Y U sing your free hand, slide the bar through the loops. Remove your fingers from the loop. The strap should wrap around the bar evenly and slide loosely and freely around the bar. See figure Z. Figure W Figure Y Figure X Figure Z