Bowflex Ultimate Assembly and Owners Manual - Page 34

34 START FINISH START FINISH Back Exercises Narrow Pulldowns Shoulder Extension (with elbow flexion) Muscles worked: This exercise emphasizes the latissimus dorsi, teres major and rear deltoid which make up the large pulling muscles of your upper back. It also involves the muscles on the front of your upper arms (the biceps group) which are responsible for bending your elbows. Pulley position: Lat tower. Starting position: • Attach a single handle to each cable. • Facing the Power Rods®, grasp the handles with the corresponding hand, palms facing each other, and sit on the bench. • Position your knees directly under the pulleys and sit upright with your arms extending upward. NOTE: You may position your hips directly under the pulleys but then you must lean back slightly from hips (not the waist). • Maintain good spinal alignment, chest lifted, abs tight and maintain a very slight arch in your lower back. Motion: • Keeping your hands shoulder width, initiate the movement by pulling your shoulder blades down and together while simultaneously drawing your elbows downward to the front, and then back toward the sides of your body. • At the end of the motion, your arms should be drawn near your sides, your shoulder blades should be fully depressed toward your hips and your forearms must be upward in line with the direction of the cables (not rotated forward). • Slowly return to the starting position allowing your arms and shoulder blades to move upward fully, without relaxing the muscles. Optional motions: • Bilateral movement - both arms pulling at the same time. • Unilateral movement - performing all reps with one arm before moving to the next. • Alternating - performing one rep on one side and then the next rep on the other side. • Simultaneously alternating - both arms moving, although in opposite directions (one pulling while the other is returning). Key points: • Do not lose spinal alignment. • Keep the lats tightened throughout the entire motion. • Do not lean backward as you pull. •Keep the chest up, especially at the bottom of the movement. Lying Lat Pulldowns Muscles worked: This exercise emphasizes the latissimus dorsi, teres major and rear deltoid which make up the large pulling muscles of your upper back, and eliminates the biceps from the movement. Pulley position: Wide. Starting position: • Lie on your back on the bench, head toward the Power Rods®. Your buttocks will eventually be off the end of the bench. • Slip your arms through the handles and slide the cuffs just past your elbows and tighten cuffs. • Grasp the cable with your palms facing inward and slide your body down along the bench far enough that your arms are fully extended, knees bent and feet flat on the floor. • Although they will be overhead, position your upper arms wide, out to the sides. • Tighten your abdominals to stabilize your spine while maintaining a very slight arch in the lower back. Motion: • Initiate the movement by pulling your shoulder blades down toward your bottom while simultaneously pulling your elbows out to the sides, then down and inward toward the sides of the torso. • Slowly return to the starting position, allowing your arms and shoulder blades to move back up toward the Power Rods® without relaxing. Key points: • Do not lose spinal alignment. • Keep the lats tightened throughout the entire motion. • Release your shoulder blades at the end of each rep and initiate each new rep by depressing your shoulder blades. • This exercise may also be performed by grasping the handles, although you will have to slide farther down the bench to create starting position tension.