Bowflex Ultimate Assembly and Owners Manual - Page 92
Assembling Your Bowflex, Ultimate
View all Bowflex Ultimate manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 92 highlights
A-4 Assembling Your Bowflex® Ultimate™ Step 1: LOWER MAIN FRAME ASSEMBLY Locate the following for this step: • Lower lat tower (Item #1) • Left main frame (Item #2) • Right main frame (Item #3) • Two (2) 3/8"X3" bolts (Item #51) • Four (4) 3/8" washers (Item #54) • Two (2) 3/8" nylon lock nuts (Item #57) 2 1 Place the left main frame (Item #2) into the saddle bracket of the lower lat tower (Item #1) as shown in Figure A. Insert a 3/8"X3" bolt (Item #51) with a 54 51 washer on it through the appropriate holes, place a 3/8" washer (Item #54) and then a 3/8" nylon lock nut (Item #57) on the bolt, hand tighten at this time. Place the mating right hand side of the main frame (Item #3) next to the left side of the frame in the lower lat tower saddle bracket (Item #1) and repeat step above. Note: Hand tighten all bolts at this stage. 57 54 Figure A Components for this step are in Box 2 & Box 4 3 Unit appears like this following this assembly step Step 2: ADJUSTABLE PULLEY SYSTEM Locate the following for this step: • Adjustable Pulley System (Item #6) • Two (2) Adjustable Pulley System bolt spacers 8 (Item #7, twist tied to Adjustable Pulley System) • Two (2) 3/8"X2-1/2" bolts (Item #49) • Two (2) 3/8"X3/4" bolts (Item #46) • Four (4) 3/8" washers (Item #54) • Two (2) Adjustable Pulley System lock knobs (Item #8) 54 Remove twist ties from bolt spacers and slide Adjustable Pulley System (Item #6) into main frame uprights as 49 shown in Figure B. Note: The side with two large holes faces away from the machine. Insert both 3/8"X2-1/2" bolts (Item #49) with 3/8" washers (Item #54) into chest slide spacers and hand tighten into the back of lower lat tower (Item #1) (NOTE: DO NOT OVERTIGHTEN) 7 54 46 Note: Inserting the top bolt first will help you align the parts. Hand tighten the 3/8"X3/4" bolts (Item #46) with 3/8" washers Figure B (Item #54) into the uprights of the main frame (Items #2&3). Make sure all the holes are properly aligned and screw the two spring-loaded locking knob assemblies (Item #8) into the back side of the Adjustable Pulley System as shown in figure B. Tighten the Components for this step are in Box 4 locking knobs to the Adjustable Pulley System with an adjustable wrench. Note: Do not unwrap the two pulley assemblies that are attached to the Adjustable Pulley System at this time. • Securely tighten all bolts that have been placed on the unit up to this stage. 1 6 Unit appears like this following this assembly step